All Leclerc benches are made out of maple (natural finish), to match the looms. They are comfortable and practical, and fit under the breast beam of the loom when not in use.
OPEN END BENCH (2 SIZES)
|6384-2000||23" (58 cm)||38" (96 cm)||Artisat 36", Nilus, Inca, Mira and Fanny loom|
|6384-4000||26" (66 cm)||44" (120 cm)||Nilus II, Colonial, Nilart and Kebec loom|
ADJUSTABLE HEIGHT BENCH
Bench recommended for the Compact 24", the Artisat 24", the Minerva loom
and for the table looms when used on a stand.
Adjustable in height from 21" to 25" (53 to 63,5 cm). The lenght is 24" (61 cm).
|Selecting the proper Loom Bench is one of the most important decisions a
weaver must make. The ability to weave over long periods of time without excessive
interruptions for fatigue depends heavily on the weavers comfort.
Up until now, finding a Bench with just the right height and seating area has been difficult, but even when that is accomplished, the most common complaint by weavers is the leg numbness experienced from the seat edge cutting into the back of the legs(espeacially from shorter weavers).
Leclercs new Rocking Bench has solved the dilemma.
Adjustable in 1" increments from 21" to 26 3/4" this Bench will satisfy virtually all height requirements. In addition, the seat can be set at two additional angles(84 and 78) at any height providing an aligned surface to the
back of the Leg when the Treadles are being depressed. This alignment eliminates the seat edge cutting into the back of the leg shutting off blood circulation.
As an additional feature, if the weaver prefers, the seat can be allowed to move or float with the body thru the full 90 to 78 degree arc so the seat is always aligned flush with the angle of the leg.
With a full 12" by 24" seat area, this Bench will provide maximum comfort over extended weaving periods.
Complementary Bench Bags